Cardinal RV Club

Another reason that I re-skinned my truck rather than buy new, No DEF.

I would go even farther and replace both rear springs. While the driver side is showing the most sag the passenger side likely has sagged as well just not as much.

Looks good. At least your trailer is newer and taller so it will work with the newer trucks. I started to look at new trucks a while back and discovered that the bed rail height is just a little higher than the overhang height of my trailer. So I have 3 choices: 1 new truck with an after market bed,...

I think it is a 2 digit display.

.453 is the stem bore needed for all car and most truck and trailer wheels. The larger isn't usually found until larger trucks & semi trailers. As far as the 100psi I would assume that they will not read higher than that I know on my truck it just says high if the tires go higher.

On our way home a little over 2 weeks ago we would have had to self quarantine on our site for two weeks in Kentucky. I am assuming others will be similar.

Looking good Dennis.

Any chance we will see it at the national this year? If not I may have to stop and see it on the way back.

Mine is 4X4 partly because we live in Michigan and partly because the big diesels have so much torque that it is real easy to spin the tires on start up. I think I engage 4 wheel almost as often in the summer as I have to make a left turn on to a busy highway and every time it is wet I put it in 4 a...

Anyone here on NB I-75 north of Atlanta a little after noon today. It was a big one that went buy me so quick I didn't get much look at it.

You're original post said the truck had 16000 km on it. Now it looks like it is 160,000 km. That is a lot of difference. I am not sure that everyone's advice would be the same. You have put way more into the truck than I have on mine with about the same miles but several years older. Give everyone a...

I'd take a look at the u-joints.

Northbound today coming into Ky. on I-65 a Cardinal with Michigan plates was pulling out as we pulled in. They probably didn't see that we were a Cardinal.

We met a bird this morning about 11 am on I -59 near mile marker 131 in Mississippi. We were headed north it was a newer bird chasing a ford dually.

When mine died it seemed to be that the buttons were not sending signals to the main part of the unit. I removed the front cover that had the buttons on it and unplugged the ribbon cable, reinstalled and everything is good again.

I'm glad you finally found it. I hope you left the new wires on the outside of the axle. I eliminated the wire on the inside of the axle by gong to discs. It sounds like it took me less time to do the conversion than it took you to find the problem