slide out unlevel still
-
- Posts: 324
- Joined: Thu Feb 01, 2007 1:30 pm
- Location: Washington Burlington
- Cardinal Owners: Cardinal 31RKLE
- Location: Washington Burlington
slide out unlevel still
Hi folks: Well, we camped 4 nights after major warranty work on my slide out (see previous post). All went pretty well, but I have a question. My floor on the kitchen slide is still NOT level--it's better, but the table is noticeably unlevel compared to the rest of the rig. The dealer said it was fine. I'm thinking I might just shim the wall side of the table up level and forget it! Or, should it be level?
How many of you folks have the floor of the coach and slide both at the same "bubble" in the your carpenter's level? Thanx, Mark
How many of you folks have the floor of the coach and slide both at the same "bubble" in the your carpenter's level? Thanx, Mark
2007 Cardinal 31RKLE
Hijacker 21K underfloor mount
Fifth Airborne pin box
2006 Ford F350 PSD extended cab
1990 Seaswirl fishing boat!
Kiki (the cat)
Hijacker 21K underfloor mount
Fifth Airborne pin box
2006 Ford F350 PSD extended cab
1990 Seaswirl fishing boat!
Kiki (the cat)
- campswithcritters
- exempt member
- Posts: 3417
- Joined: Sat Apr 08, 2006 2:19 am
- Location: Texas Most of the year!
- Cardinal Owners: 2005 34RLT
- Skype ID: campswithcritters
- Location: Texas New Caney (Deceased)
Mark, What I would check would be to see if the facia board of the slideout is an even distance from the rig wall top and bottom. This will ensure you have a decent seal to keep out wind, rain, etc and keep your heated or cooled air inside the rig. The seal behind the facia board should not have gaps from the rig wall, but also not pressing hard enough to loosen the facia from the slide. If not even from top to bottom adjustment needs to be made at the outboard end of the slide out arms under the slide. If not sliding out far enough or sliding out too far (trying to loosen the facia) it will need adjustment at the outboard end of the slide out actuator rod (be sure to leave some gap between the nuts for hydraulic creep). Can someone provide the link to Mark for lippert slide adjustment? I am overseas again so don't have my favorites on this machine.
Bruce
Bruce
Bruce & Sharon Full-time since Nov 06
Boogie, & Jack ("the critters")
Boogie, & Jack ("the critters")
- Future Fulltimers
- Posts: 847
- Joined: Thu Mar 16, 2006 5:35 pm
- Location: Tennessee McMinnville
- Cardinal Owners: 2006 30TS
- Location: Tennessee Eastern (Deceased)
Mark, here is the page(s) Bruce is talking about. This is from the slide manufacturer.
http://www.lci1.com/service_owners_manu ... deouts.htm
http://www.lci1.com/service_owners_manu ... deouts.htm
Wayne & Peggy Williamson
Rocky
GoodSam Lifetime Members
2006 30TS
2007 Silverado 3500 Classic 6.6L D'Max
AirSafe 25k hitch
Rocky
GoodSam Lifetime Members
2006 30TS
2007 Silverado 3500 Classic 6.6L D'Max
AirSafe 25k hitch
- pops91710
- Posts: 180
- Joined: Sun Sep 10, 2006 9:31 am
- Location: California Chino
- Cardinal Owners: 2006 30 WB LE
- Location: California Chino
None of the manuals looks like my bedroom unit.Future Fulltimers wrote:Mark, here is the page(s) Bruce is talking about. This is from the slide manufacturer.
http://www.lci1.com/service_owners_manu ... deouts.htm
Mike Harrington, Chino, CA.
2006 Cardinal WB/LE 30'
2003 F250 Superduty V10, 4X4, 4.30 axles and Gear Vendors over/underdrive.
With one happy wife now 45 years ago!
USAF Weapons/Munitions Specialist 1966-1973 Vietnam Vet 1970-71
2006 Cardinal WB/LE 30'
2003 F250 Superduty V10, 4X4, 4.30 axles and Gear Vendors over/underdrive.
With one happy wife now 45 years ago!
USAF Weapons/Munitions Specialist 1966-1973 Vietnam Vet 1970-71
- Future Fulltimers
- Posts: 847
- Joined: Thu Mar 16, 2006 5:35 pm
- Location: Tennessee McMinnville
- Cardinal Owners: 2006 30TS
- Location: Tennessee Eastern (Deceased)
One of these should be the proper one.
http://www.lci1.com/Service%20Owners%20 ... ll-Web.pdf
http://www.lci1.com/Service%20Owners%20 ... ut-Web.pdf
http://www.lci1.com/Service%20Owners%20 ... ll-Web.pdf
http://www.lci1.com/Service%20Owners%20 ... ut-Web.pdf
Wayne & Peggy Williamson
Rocky
GoodSam Lifetime Members
2006 30TS
2007 Silverado 3500 Classic 6.6L D'Max
AirSafe 25k hitch
Rocky
GoodSam Lifetime Members
2006 30TS
2007 Silverado 3500 Classic 6.6L D'Max
AirSafe 25k hitch
- pops91710
- Posts: 180
- Joined: Sun Sep 10, 2006 9:31 am
- Location: California Chino
- Cardinal Owners: 2006 30 WB LE
- Location: California Chino
Future Fulltimers wrote:One of these should be the proper one.
http://www.lci1.com/Service%20Owners%20 ... ll-Web.pdf
http://www.lci1.com/Service%20Owners%20 ... ut-Web.pdf
No, I already saw those before. Mine has the ram down the middle of the slide-out's frame.
Mike Harrington, Chino, CA.
2006 Cardinal WB/LE 30'
2003 F250 Superduty V10, 4X4, 4.30 axles and Gear Vendors over/underdrive.
With one happy wife now 45 years ago!
USAF Weapons/Munitions Specialist 1966-1973 Vietnam Vet 1970-71
2006 Cardinal WB/LE 30'
2003 F250 Superduty V10, 4X4, 4.30 axles and Gear Vendors over/underdrive.
With one happy wife now 45 years ago!
USAF Weapons/Munitions Specialist 1966-1973 Vietnam Vet 1970-71
- Future Fulltimers
- Posts: 847
- Joined: Thu Mar 16, 2006 5:35 pm
- Location: Tennessee McMinnville
- Cardinal Owners: 2006 30TS
- Location: Tennessee Eastern (Deceased)